<div dir="ltr"><div><div><div><div><div><div><div><div><div>Hello<br></div>I was wondering if anyone has used a Arduino to get the N1 & N2 gauges operational?<br><br></div>From the information I have found there is a 3 phase generator for the N1 & N2 mounted on the engine. The gauges have a 3 phase motor connected to a flux coupling (like is used in a mechanical speedometer) to drive the pointer. Once the engine is operating the N1 & N2 are self powered.<br><br></div>I found a chart that lists the generator RPM vs Indicator % RPM<br><br></div>0 gen = 0 %RPM<br>840 gen = 20 %RPM<br>2520 gen = 60 %RPM<br>4200 gen = 100 %RPM<br><br></div>So a question on frequency of the generator, would vary with generator RPM <br><br></div>Looking at one leg of the generator <br><br>0 gen = 0 Hz = 0 %RPM<br>840 gen = 14 Hz = 20 %RPM<br>2520 gen = 42 Hz = 60 %RPM<br>4200 gen = 70 Hz = 100 %RPM<br><br></div>Just looking for ideas<br><br></div>David<br></div>N9070U 737-222<br></div>