[simpits-tech] Flap gauge
Ray S.
raysot at comcast.net
Mon Jun 2 19:19:48 PDT 2014
Kinda makes me want one!
Sent from my iPad
On Jun 2, 2014, at 17:05, Matt Bailey <dabigboy at cox.net> wrote:
> On Mon, 2 Jun 2014 18:59:53 -0500
> Matt Bailey <dabigboy at cox.net> wrote:
>
>> Not exactly...keep in mind I don't have the schematic so I am just
>> going off what I observe.
>>
>> To put the needle at any given point in its normal range of motion,
>> one of the three inputs will have FULL reference voltage (so 5v, in my
>> case), while the other two needles receive two different voltages
>> that, when combined, should equal the reference voltage. So a signal
>> might look like this:
>>
>> Input A: 5v (fixed for a given 90* range)
>> Input B: 2v
>> Input C: 3v
>
> WHOOPS, correction....the line with Input A should read:
>
> Input A: 5v (fixed for a given 120* range)
>
> I am still in air-core mode. :P
>
> --
> Matt Bailey
>
> Keeping It Real:
> Sabreliner 60 Flight Simulator
> Serial # 306-61 - N1JX
> http://sabrelinersim.com
> _______________________________________________
> Simpits-tech mailing list
> Simpits-tech at simpits.org
> http://www.simpits.org/mailman/listinfo/simpits-tech
> To unsubscribe, please see the instructions at the bottom of the above page. Thanks!
More information about the Simpits-tech
mailing list