[simpits-tech] May the Force Feedback be with you...

[Akin, Keenan L]

Thanks Stig.  Well, as I said, it is just a schematic.  The actual mechanical arrangement can be modified to a more practical and durable design.   The servo could be replaced with a small air cylinder or a large high torque servo (such as is used in 1/4 scale R/C planes).

It seemed like a simple method to produce the desired load and trim inputs.

Keenan



-----Original Message-----
From: Stig Joergensen [mailto:stig.joergensen@clearsky.dk]
Sent: Monday, February 10, 2003 1:40 PM
To: simpits-tech@simpits.org
Subject: RE: [simpits-tech] May the Force Feedback be with you...


Well i want to comment on it - just don't know what to say :-) except it
might work.....

this bigest problem is the bar that are controled by the servo, is must
be very stable and im afraid that the servo can not hold it under the
preassure...

/Stig


> -----Original Message-----
> From: Akin, Keenan L [mailto:keenan.l.akin@boeing.com]
> Sent: 10. februar 2003 20:29
> To: simpits-tech@simpits.org
> Subject: RE: [simpits-tech] May the Force Feedback be with you...
> 
> 
> I am surprised that no one has made any comments about the 
> airless method schematic I posted.  Either no one received it 
> or it is so ridiculous that no one wants to discuss it.
> 
> Keenan
> 
_______________________________________________
Simpits-tech mailing list
Simpits-tech@simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above page.  Thanks!