Home » Simpit Discussion » simpits-tech » Re: [simpits-tech] Controller for LED's
Re: [simpits-tech] Controller for LED's [message #2103] Mon, 28 February 2011 16:23
Justin Messenger  is currently offline Justin Messenger
Messages: 159
Registered: January 2009
Senior Member
The Opencockpits USBOUTPUTS card also handles 64 outputs and can run up to 50
volts through the connectors which are built right onto the board. With shipping
it also costs about half as much.
http://www.opencockpits.com/catalog/electronic-cards-iocards -outputs-lampsleds-c-21_44.html

You do however, have to learn SIOC script which takes some time.

It looks like Ruscool has a much easier to use interface.
 
Justin
www.SimAdventure.com 
 
------------------------------------------------------------ ------------------------------------------------------------ ------------------------------------------------------------ ---------------------------------------


http://www.ruscool.co.nz/64_op.html
 
 
 
 
John makes bits for us at work, but has branched out into “consumer” components
as well..  I am going to be using his 64 output board (as soon as the world
stops shaking), and he can supply an SDK rather than using his FS9/X GUI app..
 
 
SeanG

________________________________

From:simpits-tech-bounces@simpits.org [mailto:simpits-tech-bounces@simpits.org]
On Behalf Of Roy Coates
Sent: Tuesday, 1 March 2011 7:48 a.m.
To: Simulator Cockpit Builder's List
Subject: [simpits-tech] Controller for LED's
 

Chaps,
           About to start building another simpit and I'm looking for a
controller I can use to control low-current devices like LED's.

At most, I might have a small relay or two - nothing major.

Top of my list right now is the Phidget 0/16/16 but feel that this is expensive
for what it is. (~$100)

I don't have time to build anything, is anyone aware of another off-the-shelf
interface that might do the job?

Cheers,

Roy .



_______________________________________________
Simpits-tech mailing list
Simpits-tech@simpits.org
http://www.simpits.org/mailman/listinfo/simpits-tech
To unsubscribe, please see the instructions at the bottom of the above page. Thanks!


Phantoms Phorever!!
Previous Topic:Re: [simpits-tech] Controller for LED's
Next Topic:[simpits-tech] Controller for LED's
Goto Forum:
  


Current Time: Wed May 22 12:47:25 PDT 2013

Total time taken to generate the page: 0.01032 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 2.7.7.
Copyright ©2001-2007 FUD Forum Bulletin Board Software